ONSLOW SITE

CUSTOMIZATION
TUBE AMP FAQ
TECH HELP LIBRARY
VINTAGE GALLERY
ABOUT RICK
CONTACT RICK

Push-Pull



  • A method of increasing the efficiency of an amplification stage by splitting the signal into 2 separate halves using a phase inverter. The first half or positive cycle is sent to one amplifier stage and the second half or negative cycle is sent to another amplifier stage. The two halves are then combined to reproduce the original signal.

  • Usually, but not always used in ClassAB mode (VOX AC 30 is Class A Push-Pull circuit)






Definitions
XML Revisions of $tag
Valid XHTML :: Valid CSS :: Powered by pnWikka 1.0 (A wiki fork from WikkaWiki)
 

 

Fender®, Marshall®, Ampeg®, Boogie®, Vox® and any other registered trademarks referred to on this page are the properties of their respective owners and are not affiliated in any way with Rick Onslow

©2001 - 2024 Rick Onslow
all rights reserved

 

--------