ONSLOW SITE

CUSTOMIZATION
TUBE AMP FAQ
TECH HELP LIBRARY
VINTAGE GALLERY
ABOUT RICK
CONTACT RICK

Oldest known version of this page was edited on 2008-02-06 16:00:33 by Rick [ ]

No Overdrive Channel-Switching


Amp stays on Clean channel and will not switch to Overdrive channel


  • Unplug the foot-switch and connect a regular guitar cable to the foot-switch jack.

  • On 3 channel mods that use a stereo foot-switch plugging a mono cable into the stereo jack should cause the amp to switch to the second channel. On 2 channel mods nothing will happen at this stage.

  • Short the tip of the guitar cable to the chassis. 2 channel mods should switch to the overdrive channel and 3 channel mods should switch to Lead mode

  • If the amp seems to switching properly when doing these tests go to the FootSwitchDiagnosis page, if not:

  • Check for loose foot-switch jack, the jack must be tight for a proper ground connection

  • Measure the venue's AC voltage supply, especially with outdoor festivals that use generators









ChannelSwitchingDiagnosis
Last Revision : 2008-02-06 16:00:33
Last Editor : Rick
Owner : Rick

 

Fender®, Marshall®, Ampeg®, Boogie®, Vox® and any other registered trademarks referred to on this page are the properties of their respective owners and are not affiliated in any way with Rick Onslow

©2001 - 2022 Rick Onslow
all rights reserved

 

--------